Our high school has a couple gantry based CNC routers running version 2.5. From perusing the list, it seems like 2.8 is fairly stable even though its not released. I've got a pendant and some other add-ons I want to install. I'd rather put the effort into getting them working on a new system than battling with the old one.

This would be a fresh install, on a new hard disk. If I run into issues I need to be able to fall back quickly.

I'm comfortable with compiling from source if need be, but was hoping that there is an ISO out there that I could use.

I installed in a VM for testing purposes going off https://forum.linuxcnc.org/9-installing-linuxcnc/36413-linuxcnc-debian-9-stretch-uspace-2-7-to-2-8. I ended up with 2.9 instead of 2.8. I can grab the 2.8 branch from git.

I don't have a specific need for 2.8 over 2.7. I want to avoid installing 2.7 and having 2.8 come out soon after.

Are there any reasons I should not attempt 2.8?

Is there anything I can do to help nudge 2.8 along?

Thanks,

    Andy




_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to