Gene says that he can't start Linuxcnc after the error occurs. Is there a possibility that there could be some kind of a config issue preventing Linuxcnc from properly initializing the cards on start up?
Todd Zuercher P. Graham Dunn Inc. 630 Henry Street Dalton, Ohio 44618 Phone: (330)828-2105ext. 2031 -----Original Message----- From: Peter C. Wallace <[email protected]> Sent: Tuesday, December 10, 2019 4:28 PM To: Enhanced Machine Controller (EMC) <[email protected]> Subject: Re: [Emc-users] Need a power signal independent of linuxcnc. I did a quick test to see if I could confuse a 7I76 by sending it garbage/interrupted transmissions (cycling the FPGA side power while doing high speed comms. I did this 500 times without the 7i76 I/O processor ever requiring a power cycle to recover. I still think this is some other issue (power?) Peter Wallace Mesa Electronics _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
