> On 2020-02-01 20:46, Jon Elson wrote: > > On 02/01/2020 08:35 PM, Thomas D. Dean wrote: > >> I have been using linuxcnc 2.9.0~Pre0 from sources, run in place. > >> Until today, it has worked, mostly. Before today, about 2x per week > >> it would freeze and I had to cycle power to get it working. Now, > >> linuxcnc freezes. > >> > > Does it ONLY freeze when LinuxCNC is running? But, just keep working if > > you DON'T start LinuxCNC? > > In that case, the most likely problem is the BASE_THREAD has too short a > > period. Try increasing > > the BASE_THREAD period in the .ini file and see if that fixes it. > > > > I changed the BASE_THREAD period by a factor of 10x then 100x, with the > same result.
Had similar problems and removed graphics card, used the builtin instead and it started to work. Pretty sure I use buster on several machines. _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users