Greetings all; I have added a 40 amp SSR in the relay box with the two that are sequencing the spindle's psu startup for a soft start, but its not intentionally connected to those 2 other than as a power src when its enabled. Except this one is to be enabled by the E-stop.out signal when its on, f1 pushed once after start. The idea is to turn on motor power etc to the remainder of the system with the F1 key.
I have a std 5 axis bob on the 5i25's P2. But I am not having any luck finding what would be gpio.020, aka the 5i25's p2 pin 3 at the bob that's plugged into p2 on the 5i25. I can find 2 or 3 pins at ground when LCNC is started, and enabled, but not on the x connector. All are logic 1 or 5 volts on a DVM then LCNC is stopped. So what would be the correct pin of a std bob to hit the enable signal of what the what the bob thinks is x-enable? If it was the 5i25 p3, it would be gpio.003. But its not and I'm lost, What I want to do is feed the bobs 5 volts to the + label of the SSR, and send a logic 0 to the - terminal to enable the SSR. But what I see in dmesg and in halconfig or halmeter, isn't match my old thinker's conclusions. And it looks like I should be using an in-not because e-stop-out is high when F1 is on and I need to invert, only when LCNC is running. Thanks all. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
