On Tue, May 26, 2020 at 3:01 PM Gene Heskett <ghesk...@shentel.net> wrote:
> > Those closed loop motors and controllers have arrived, and I puzzled by a > total lack of docs other than the u-step ratios printed on the cover. > Thats covered by dip sw1-4, but its a 6 pos switch, and 5 & 6 are in > Chinese pictograms. I'm following this because, as said, I plan on doing the same. However I always read the docs BEFORE buying, no docs, I don't buy. Post a photo of the Chinese characaters, I have someone here fluent in Chinese. Also you can try Chinese OCR and then apply Google Translate. http://www.i2ocr.com/free-online-chinese-traditional-ocr My guess about the cable length mismatch is that the seller you bought this from gathers parts and packages them and this motor was made for a use case that did not include this controller. When googling for the instruction, look for related controllers as I'd bet the firmware was written to run on many different sizes of controllers, not just the one you have. Many of these are Leadshine clones so look at Leadshine web site. -- Chris Albertson Redondo Beach, California _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users