Greetings all you 3d printer users; 1; Which is a measure of the OD of the rendered pulley, those areas of the preview gfx are blank, although the scale marks are there, they are drawn behind the sprocket image. so one could get a very rough idea of the total radius of the finished gear in mm. Am I missing a font, or is this a more serious concern that will need me to make the gear before I can determine how it fits?
2; This motor runs uncomfortably hot, and I've not found anything to indicate the controller goes into a low current mode at balance, I left it running at about 1500 revs for half an hour and cannot lay a hand on it to pick it up, and an extended stop didn't seem to cool it any, and since that heat will telegraph up the motors 8mm shaft to the PLA, is this going to be a life of the sprocket limiting factor because the PLA will soften and eventually cold flow to a loose and likely out of concentricity warpage? 3; I have the pi3b I took off the Sheldon, and another of those 5v5a supplies, and I've downloaded the octo-pi image that includes that slicer. So that I think solves the slic3r problem of having to compose a working multi-variable config for slic3r. Unless someone has a slic3r config to drive an Ender that they can share. Thanks all. The printer might show up Wednesday. Maybe... One thing seems obvious, it really doesn't matter what the skin color is, we the people are sick and tired of blacks being killed by police just for the fun of it and no one gets convicted. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
