On Friday 05 June 2020 21:36:00 Gregg Eshelman via Emc-users wrote: > Elmer's disappearing purple school glue stick seems to be a favorite > with 3D printers. I've used Duck brand archival acid free glue stick. > Rub all over the build plate, drag a wet paper towel around to smooth > it. By the time the bed heats up the glue is dry. When the bed cools > the print pops loose. > > On Friday, June 5, 2020, 1:19:43 PM MDT, Gene Heskett > <ghesk...@shentel.net> wrote: 92% iso alky isn't getting it really > clean of hair spray, whats next? fine sandpaper? I have up to 2000 > grit. Acetone? The middle of the plate is losing its textured feel > but is otherwise undamaged. > I did 2 things in desperation. I threw away the paper gage and brought it to a very gentle touch. And I went back to a 15mm extra wide raft. That half a 32 tooth sprocket is finally going without knocking the raft loose, but it took in a hour an 16 minutes just to lay the raft.
I should be able to see if tightening up the x belt helped make better teeth by the time I wake up again. Thanks all Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users