Just a quick question fellows. I need to send the config files to Andy. Now my USB is Copy protected in Linux. Don't know how it happened but how to I disable it so I can copy to USB?
Regards Andrew On Sun, Jul 26, 2020, 6:24 AM N <nicklas.karlsso...@gmail.com> wrote: > > Hi, > > TinyG is supposed to have S curve accel and limited jerk. It might be > > worth looking at for approach. Should be easy since it is pretty much > > linuxcnc but embedded. > > Just a comment following up on an earlier post; maybe a week ago or so. > > Just poking the bear. :-) > > > > Dave > > Forgot about the limit3 function. If instant values are fed to the PWM > limit3 motion or actually close to limit3 function because of imperfections > is what I would expect then measuring position. To get good following > accuracy input signal must follow what motor actually could achieve so this > limitation must be before positions i fed to control looop, the PID > regulator and not after. Limiting the PWM signal will limit what motor > could actually achieve and most probably will increase following accuracy > then motion is not smooth. If smooth movement is needed then situation > might be different, harder to tell. > > > Nicklas Karlsson > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
