On Saturday 07 November 2020 13:30:11 andy pugh wrote: > On Sat, 7 Nov 2020 at 18:03, Gene Heskett <[email protected]> wrote: > > With the servo repeat rate of 1khz, and the high speed I am spinning > > this encoder, up to 15k or so is there any chance I could get an > > advanced warning of this condition > > Set hm2.....encoder.N.quadrature-error-enable and watch the > quadrature-error pin?
looks ok, except it was "quad-error-enable" when I went to apply it. reported an error on the first restart, nothing since. I took the cover off that encoder, looked it over, and put it back together, and now its working flawlessly again. As a tech, I hate that chain of events. Before I took it off the machine, the tach was going berzerk, at least 25% wibbles, re-assembled and re-installed, is now solid as a rock. No electrical connections were disturbed, they are all soldered anyway. Thanks Andy. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
