Where did you get the image? Could you post the complete path? > -----Original Message----- > From: dave engvall [mailto:dengv...@charter.net] > Sent: April-06-21 10:45 PM > To: emc-users@lists.sourceforge.net > Subject: Re: [Emc-users] Rpi4B OS > > > > On 4/6/21 10:24 PM, dave engvall wrote: > > OK, so I download 20210210_raspi_4_buster.img.xz > > check sha256 and it matches > > make a *.img out of it. > > attempt to install the rpi-imager ....� no x86 version.�� so use dd > > dd to SD: � dd bs = 1M if=202010210-raspi_4.buster.img > > of=/media/dave/3339-3839/rpi_4_buster > > unmount > > put SD in rpi4B and power up > > get the same error� messages as before: > > > > autoboot.txt not found > > config.txt not found > > recover4.elf not found > > recovery.elf not found > > start.elf not found > > SD boot failed > > > > So is the .img missing bits and pieces or are there steps beyond the > > dd of the image that need to > > add the missing files?� If so where do I look for these files? > > > > Dave > > > > > > On 4/6/21 4:47 PM, andy pugh wrote: > >> On Tue, 6 Apr 2021 at 22:56, Feral Engineer > >> <theferalengin...@gmail.com> wrote: > >> > >>> Have you experienced crashes in lcnc on a pi4b? > >> TBH I haven't really used it. I have lots of other LinuxCNC machines > >> which actually have monitors. > >> > > > > > > > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users