Tis looking easy. lsb_release -ic debian stretch uname -r 4.9.0-8-rt-amd64
So this has been downloaded and is now upgrading deb http://linuxcnc.org stretch base 2.8-rtpreempt Just to be safe I'm also copying the /home folder to a USB drive. Never did install samba like I did for the PI4LINUXCNC so I can access it from the network. Thanks Andy. Hopefully no other questions. John > -----Original Message----- > From: Andy Pugh [mailto:bodge...@gmail.com] > Sent: September-14-21 10:58 PM > To: Enhanced Machine Controller (EMC) > Subject: Re: [Emc-users] Safely Upgrading LinuxCNC > > > > > On 14 Sep 2021, at 23:41, John Dammeyer <jo...@autoartisans.com> wrote: > > > > Short of installing the OS and LinuxCNC all over again as if it were a > > clean hard drive is there a way to update the OS and LinuxCNC > without losing everything that's on the hard drive? > > It should be easy. > > You simply need to change the software repository to 2.8 and allow updates. > > No need to change OS or anything else. And everything should work just the > same after. > > http://linuxcnc.org/docs/2.8/html/getting-started/updating-linuxcnc.html > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users