On Sat, 8 Jan 2022 at 14:27, Robin Szemeti via Emc-users <emc-users@lists.sourceforge.net> wrote: > > It was some years ago when I tried it, it was fine on thicker sheet, but > not thin sheet, like I said, I expect there have been improvements in the > trajectory planner since then.
There have been improvements to the TP and also some plasma-specific tweaks, to the extent that I have read that LinuxCNC + PlasmaC is now at least as good as the commercial controls and in many cases better. (Note that I have never run a Plasma, this is purely from reading the forum posts) There is a plasma primer in the docs: http://linuxcnc.org/docs/2.8/html/plasma/plasma-cnc-primer.html There is a forum section on plasma cutters here: https://forum.linuxcnc.org/plasma-laser And a section specific to the Plasmac interface: https://forum.linuxcnc.org/plasmac -- atp "A motorcycle is a bicycle with a pandemonium attachment and is designed for the especial use of mechanical geniuses, daredevils and lunatics." — George Fitch, Atlanta Constitution Newspaper, 1912 _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users