ons 2022-11-30 klockan 12:11 -0500 skrev Matthew Herd: > A drill for an entry hole is never a bad idea. Other options include > using > a tool with a smaller diameter or fewer flutes. Can you improve chip > evacuation? That's never a bad idea in any event. If feasible, a > vacuum > or some repeated blasts with the air gun are helpful. Also, can you > reduce > the ramp angle for the helix? Have no really good method to get the chip out of the slot though could stop and manually remove most of it and drill thru holes. Tried reducing the ramp angle but did not help or only a little bit.
Smaller mill or first drilling thru holes is ideas I have. > > On Wed, Nov 30, 2022 at 12:09 PM Nicklas SB Karlsson <n...@nksb.eu> > wrote: > > > Milling a deep pocket spiral down work great first turn but after a > > while torque is not enough and mill stop. Suspect it is because > > mill > > have to cut old chips in addition to machining part. > > > > Maybe it is a good idea to use drill bit a little bit smaller than > > slot? > > > > > > Nicklas Karlsson > > > > > > > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
