On Tue, 5 May 2026 18:58:31 +0100 andy pugh <[email protected]> wrote:
> > The most common causes of no motion on step/dir systems with our > > hardware are: > > > > 1. Too short step times (use double the manufacturers minimum value > > as a starting point) > > > > 2. wiring errors (polarity, step/dir swapped, using differential > > wiring whan ont applicable etc, etc) > > > > 3. Too high accel limits so immediate stalls > > I would add: > > 4. Drive disable inputs wired as if they were enables. Thanks for your suggestions. I'll check when I'm at the machine. Might take a short while. Marco _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
