All First question Does it stop between 4-5 minutes?
Second question Do you have a querier on the network? If unsure then you need one configured on the router( global config and on each interface of the router that you would like the streams to cross-VLAN’s) Jason Parker From: Sheil,Sean M [mailto:[email protected]] Sent: Wednesday, December 21, 2011 6:38 PM To: Enterasys Customer Mailing List Subject: [enterasys] Running Symantec Ghost across network Has anyone had success using Symantec Ghost to re-image hard drives across the network utilizing multicast. The process will run for a period of time and then hang or fail. On a standalone C2G124-48, it will usually get to 15% and then hang. Looking for advice from anyone who has managed to get this process working properly. Our configuration is very simple: S4 at the core with the following commands: Set igmp enable xxxx,xxxx,xxxx, etc Set igmp query-enable xxxx,xxxx,xxxx etc Routing is handled on the S4 E1 at building edge with following commands: Set igmp enable Set igmp query-interval 60 Set igmp response-time 120 Set igmp mode vlan xxxx Set igmp mode ip address 10.10.1.253 (unused IP address) G3’s connected to E1’s Set igmpsnooping interfacemode ge.*.* enable Set igmpsnooping adminmode enable Set igmpsnooping groupmembershipinterval 60 Set igmpsnooping maxresponse 120 Regards, Sean --- Sean M. Sheil, GSEC Sr. Systems Administrator Northwest Missouri State University 660.541.3021 Northwest WILL NOT ask for your username/password information via e-mail. * --To unsubscribe from enterasys, send email to [email protected]<mailto:[email protected]> with the body: unsubscribe enterasys [email protected]<mailto:[email protected]> --- To unsubscribe from enterasys, send email to [email protected] with the body: unsubscribe enterasys [email protected]
