Jason,
The 4-5 minutes sounds about right. Unicast works fine, but
not a great solution of course. I do have a querier on the core network.
Commands used are below under the S4 config statements.
Sean
From: Parker, Jason [mailto:[email protected]]
Sent: Wednesday, December 21, 2011 5:56 PM
To: Enterasys Customer Mailing List
Subject: RE:[enterasys] Running Symantec Ghost across network
All
First question
Does it stop between 4-5 minutes?
Second question
Do you have a querier on the network?
If unsure then you need one configured on the router( global config and on each
interface of the router that you would like the streams to cross-VLAN’s)
Jason Parker
From: Sheil,Sean M [mailto:[email protected]]
Sent: Wednesday, December 21, 2011 6:38 PM
To: Enterasys Customer Mailing List
Subject: [enterasys] Running Symantec Ghost across network
Has anyone had success using Symantec Ghost to re-image hard drives across the
network utilizing multicast. The process will run for a period of time and
then hang or fail. On a standalone C2G124-48, it will usually get to 15% and
then hang. Looking for advice from anyone who has managed to get this process
working properly.
Our configuration is very simple:
S4 at the core with the following commands:
Set igmp enable xxxx,xxxx,xxxx, etc
Set igmp query-enable xxxx,xxxx,xxxx etc
Routing is handled on the S4
E1 at building edge with following commands:
Set igmp enable
Set igmp query-interval 60
Set igmp response-time 120
Set igmp mode vlan xxxx
Set igmp mode ip address 10.10.1.253 (unused IP address)
G3’s connected to E1’s
Set igmpsnooping interfacemode ge.*.* enable
Set igmpsnooping adminmode enable
Set igmpsnooping groupmembershipinterval 60
Set igmpsnooping maxresponse 120
Regards,
Sean
---
Sean M. Sheil, GSEC
Sr. Systems Administrator
Northwest Missouri State University
660.541.3021
Northwest WILL NOT ask for your username/password information via e-mail.
* --To unsubscribe from enterasys, send email to [email protected] with
the body: unsubscribe enterasys [email protected]
* --To unsubscribe from enterasys, send email to [email protected] with
the body: unsubscribe enterasys [email protected]
---
To unsubscribe from enterasys, send email to [email protected] with the body:
unsubscribe enterasys [email protected]
