Hey Chris,
I do this all the time. Measure number tool - edit regions - in the
lower left of the dialog box, check "Always show on top staff," and
it's done. Did I misunderstand something?
On Aug 24, 2005, at 7:35 PM, Christopher Smith wrote:
Greeting general knowledge base,
FinMac2005
I can't believe I am doing this for the first time, but I want
measure numbers to appear over the staff at the beginning of each
system (no problem so far) AND where I specify, usually at double
bars (this is the problem.)
I can force a measure number to appear at a double bar by opt-
clicking the measure, BUT it only appears to apply to THAT staff. I
want ALL twenty or so extracted parts to show the measure number at
the double bar too.
Do I have to go through and opt-click EVERY staff in the score at
EVERY double bar? I already tried selecting the whole vertical
stack and opt-clicking; it doesn't seem to work.
No, that's why you check "always show on top staff." That means on
the extracted parts too, and it works reliably.
This is the way I always do it, so I don't know if I'm missing some
issue.
Hope this helps.
Chuck
To make matters worse, not all staves are set to show numbers IN
THE SCORE, but the top staff is forced to show numbers, so that
they appear on all extracted parts even if the staff is set not to
show measure numbers. This means that if I miss the measure by
accident, I won't know about it until AFTER I extract the part.
What is usually done in this case?
Thanks a lot.
Christopher
_______________________________________________
Finale mailing list
Finale@shsu.edu
http://lists.shsu.edu/mailman/listinfo/finale
Chuck Israels
230 North Garden Terrace
Bellingham, WA 98225-5836
phone (360) 671-3402
fax (360) 676-6055
www.chuckisraels.com
_______________________________________________
Finale mailing list
Finale@shsu.edu
http://lists.shsu.edu/mailman/listinfo/finale