I can't duplicate this. I've tried a number of times. Although I read of someone else with a similar problem
how does your ptt get it's commands? Is it a 'virtual port'? Or is it a hardwire ptt button or footswitch? What version firmware and driver? Does your radio communicate with a logging/control program? If so: In the Flex setup for 'Cat Control' What is you Cat port? What is your PTT Control port? On 11/10/2007 9:45:19 AM, Dave Kiefer ([EMAIL PROTECTED]) wrote: > Yes, it stays checked. > Nothing anywhere in the setup changes. > I just set it on a frequency and toggle between > lsb and cwl, then break in or ptt > don't work anymore. > > FireBrick wrote: > > did you check Setup>General>Options and see if All Mode Mic PTT is > > enabled. > > Mine doesn't > want to 'stay' enabled. > > I have to check this frequently. > > > > > > On 11/10/2007 12:04:43 AM, [EMAIL PROTECTED] wrote: > > > >> I am running SVN 1738 and see the same problem. Also I tried to use it > on > >> CW > >> and no go at all. This is with SDR-1000. v1.10.3 is fine. > >> > >> Joe K1RQG > >> > >> In a message dated 11/10/2007 12:54:28 A.M. Eastern Standard Time, > >> [EMAIL PROTECTED] writes: > >> > >> I > >> > don't know if anyone else has this problem. > >> > >> If I switch to cw from ssb, or the other way, the ptt or break in do > >> not > >> work. > >> If I stop SDR and restart all comes back ok. As soon as I switch > >> between > >> cw and ssb > >> again it quits. It is very consistent on 160-40m, not so much above > >> 30m. > >> Vox works no matter what happens, but it won't > >> _______________________________________________ FlexRadio mailing list FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ FlexRadio Knowledge Base: http://kb.flex-radio.com/ FlexRadio Homepage: http://www.flex-radio.com/
