I am using SVN2129 and I am trying to understand the frequency being displayed in MixW and HRD/DM780. I have the RTTY offset disabled and the frequency in VFO A is set to 7.100000 and mode is DIGU - in this case for psk. The display on Mixw shows 7097.8 when it should show 7100 since that is the displayed frequency on the F5K and the red line indicates the same on the panadapter. I have to go into mixw ptt&cat and set the digi cat correction to a -2210hz for the digi offset (actually any mode offset) then the frequency display indicates the correct frequency which doesn't make a lot of sense. For rtty using digl I have to remove the cat offset in mixw in order to get a correct frequency readout on mixw when RTTY offset is enabled for 2125 in digl.
HRD/DM780 indicates the correct frequency when operating psk - 7100000 matching the VFO A on the F5K and when I enable the RTTY offset at 2125 the display on HRD reads 7102125 as long as the mode is set to digu which is what I would expect since rtty on HRD/DM780 is done is usb mode, however, the frequency display in DM780 now starts at 7102125. Don - kx9q _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kb.flex-radio.com/ Homepage: http://www.flex-radio.com/