If you are running the SDR1000, the ext ctrl panel is available in
SETUP, but the 5000 does not display it. This is with the current
PowerSDR V 18.5. On my 1000, I use this panel to set up bandswitching
for my quadra amp.
Seems to me that the UCB would work just as well through DDutil with
the 5000, assuming the voltage levels from the parallel port are
similar to the voltage levels at the 1000's ext ctrl port. (They may
or may not be.)
I understand Phil is working on the prototype for the flexwire
interface for his UCB. Maybe then we can use it for the 5000 directly
from PowerSDR.
Jerry W4UK
At 03:58 PM 2/14/2010, Robert delaney wrote:
I am in the process of building one of the K3TUF UCB board kits
and I hope to use it with DDutil to control numerous transverters
down the road with my 5K.
I am a bit confused on the setup and would like to corespond with
someone who is running this type of setup with their 5k.
Looking at the old versions of PSDR it looks like you could
specify any or all of the 16 relays with a UCB setup screen but I
don't see it in 1.18.3 it seems that only the transverter setup
screen has any UCB info on it and it is not clear to me what relays
would be actuated by these settings.
Also looking for reccomendations on a transfer relay that could
be easily controled by this setup with multiple RF taps, at least 4
and up to 8.
73, Bob
KA9UVY
_______________________________________________
FlexRadio Systems Mailing List
FlexRadio@flex-radio.biz
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flex-radio.com/ Homepage:
http://www.flex-radio.com/
_______________________________________________
FlexRadio Systems Mailing List
FlexRadio@flex-radio.biz
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/
