I would export your current database to a safe area and then reinitialize the database and see if the problem persists.
73 Neal Campbell Abroham Neal Software www.abrohamnealsoftware.com (540) 645 5394 On Sun, Dec 5, 2010 at 5:37 PM, W8HW <[email protected]> wrote: > No TX power output using PSDR v2.0.16 > > I was running PSDR v2.0.8 TX worked > fine > about a month ago switched to PSDR v1.18.6 TX worked fine > Today I downgraded VAC to version 9.0 TX worked fine > > Now I switched to PSDR v2.0.16 and now no TX Power. Everything works fine > even digital > on RX. When I key the TX (in any mode) the unit goes into tx mode, but now > no > power out. I have tried several bands and different modes. It gives no > power > out in tune or TX. I tried CW at 50% drive and Zero power in all ways. > > What did I do to cause this? > > Thanks, Bruce, W8HW > [email protected] > > Flex- 3000 > PSDR v2.0.16 (Now) > Computer Dell computer running MS XP Professional SP3 > CPU Intel Xeon 5130 @2.00 Ghz with 2m Ran > > _______________________________________________ > FlexRadio Systems Mailing List > [email protected] > http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz > Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ > Knowledge Base: http://kc.flexradio.com/ Homepage: > http://www.flexradio.com/ > _______________________________________________ FlexRadio Systems Mailing List [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/
