Make sure you power cycle the radio. Upgrading to 2.0 loads a new firmware version and the soft reset may not have properly rebooted the radio.
-Tim -----Original Message----- From: flexradio-boun...@flex-radio.biz [mailto:flexradio-boun...@flex-radio.biz] On Behalf Of W8HW Sent: Sunday, December 05, 2010 5:37 PM To: FlexRadio@flex-radio.biz Subject: [Flexradio] PSDR v2.0.16 and now no TX Power No TX power output using PSDR v2.0.16 I was running PSDR v2.0.8 TX worked fine about a month ago switched to PSDR v1.18.6 TX worked fine Today I downgraded VAC to version 9.0 TX worked fine Now I switched to PSDR v2.0.16 and now no TX Power. Everything works fine even digital on RX. When I key the TX (in any mode) the unit goes into tx mode, but now no power out. I have tried several bands and different modes. It gives no power out in tune or TX. I tried CW at 50% drive and Zero power in all ways. What did I do to cause this? Thanks, Bruce, W8HW w...@att.net Flex- 3000 PSDR v2.0.16 (Now) Computer Dell computer running MS XP Professional SP3 CPU Intel Xeon 5130 @2.00 Ghz with 2m Ran _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/ _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/