i've had a couple boards come back with unconnected nets. this was because
of a naming issue. what does the unconnected net labels check box in the
erc actually check for. i would like to check if a net goes to more than
one pin. i did some experimenting and found i only get the unconnected net
label error when the label is not connected to anything. cutting and
pasting from design to design cuts alot of time, but if i can't find errors
due to naming, then it's nt worth it. any suggestions??
Chris Hower
DPS Telecom CAD
(559)455-1600 Ext. 136
www.dpstele.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
