Hi Rob,
The most simple way is to set the hole at the centre or at one side
of the slot with the slot small-side diameter. Add the outline of the slot
on a mechanical-layer and make a comment for the board-maker.
I'm not sure, if there are special design rules for plated slots.
I suggest to ask the boardmaker for that.
Georg
> -----Urspr ngliche Nachricht-----
> Von: Rob Porter [mailto:[EMAIL PROTECTED]]
> Gesendet: Mittwoch, 27. Juni 2001 12:45
> An: Protel EDA Forum
> Betreff: [PEDA] Pad With Slotted Hole
>
>
> Hi All,
>
> I am laying out a board with a section that needs to be
> screened off and was
> hoping to have tabs on the screen to solder into the PCB.
> My problem is, I need to create pads on the PCB that have
> slotted holes
> not the standard round hole ).
>
> Any help would be much apreciated.
>
> Thanks,
> Rob.
>
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
