Is it possible in protel to make a slit pad at all? we need to insert some
power transistors after flow soldering and on a cheap board cannot have a
pealable mask on the solder side, a slit pad would stop the pad covering
with solder for ease of insertion. I used to just get the photoplotters to
ammend the gerber info while using cadstar.
Rich Thompson
> -----Original Message-----
> From: Cliff Lawrence [SMTP:[EMAIL PROTECTED]]
> Sent: 28 June 2001 10:20
> To: Protel EDA Forum
> Subject: Re: [PEDA] AW: Pad With Slotted Hole
>
> If you're up for it you might make the script generate other types of pads
> (like slit pads) that would be useful...
>
> Cliff Lawrence
>
> [EMAIL PROTECTED]
>
> Tel:- + 44 1223 203294
> Fax:- + 44 1223 863384
>
> PCB Design Engineer
> ARCAM
> A&R Cambridge
> Pembroke Avenue
> Waterbeach
> Cambridge
> CB5 9PB
>
>
>
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
