Fabio,
from your limited comment I would assume that the drill locations do
not line up with the gerbers. This is typically caused by having the "Center
on Film" selected in the Other tab of the CAM properties. The drill and
gerber files should both be set to have the same origin, relative or
absolute set in the Other or Advanced tabs in the drill cam properties. This
is probably your problem.
Brad Velander,
Lead PCB Designer,
Norsat International Inc.,
#300 - 4401 Still Creek Dr.,
Burnaby, B.C., V5C 6G9.
Tel. (604) 292-9089 direct
Fax (604) 292-9010
website www.norsat.com
> -----Original Message-----
> From: F�bio Rizental Coutinho [mailto:[EMAIL PROTECTED]]
> Sent: Thursday, June 28, 2001 2:42 PM
> To: Protel EDA Forum
> Subject: [PEDA] Problems generating CAM files
>
>
> Since i update to service pack 6, I begin to have problems
> with the cam files generated because the drill file isn�t
> match with the others gerbers. Could anyone help me?
>
> Fabio
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
