At 21:33 28.06.01 -0400, you wrote:
>Brad wrote:
> >The drill and gerber files should both be set to have the same origin,
>relative or
>absolute set in the Other or Advanced tabs in the drill cam properties. This
>is probably your problem. <
>
>
>Brad,
>I just checked my output setup and both drill and gerber ...both are set to
>relative. This is a new feature for SP6 and it may not be functioning
>properly. For the past unteen years using Protel , I have always reset my
>origin before: 1. sending a design to an autorouter 2. generating gerbers.
>It has always worked flawlessly by resetting the origin to the workspace.
>My two cents are that the origin output is choking on the relative
>setting. I never had a problem of holes missing on my chart until I
>started using this new feature, I had two designs in the past 2 weeks that
>required answering questions from fabricators.
The Gerber uses the absolute orgin, and the NC-Drill the user defined orgin!
Protel should fix that (somewhat for the bug list?).
Do as Mike says, reset the orgin bevor you do the cam.
Edi
>Mike Reagan
>EDSI
>Frederick MD
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
