You should use sql_ippool for non-continuous pools. Ivan Kalik Kalik Informatika ISP
Dana 30/9/2008, "Marco C. Coelho" <[EMAIL PROTECTED]> piše: >I ran out of IP space in my original IP_Pool, and since the next >available addresses were non contiguous, I added a second pool. Here's >the snippet of my radiusd.conf: The problem is that the first pool >comes up and is used, but when it runs out of IP space, the second pool >never gets used. > >If the db files are deleted and freeradius restarted, should both sets >of files get recreated on start up? > > ippool main_pool { > > # range-start,range-stop: The start and end ip > # addresses for the ip pool > range-start = 64.202.227.1 > range-stop = 64.202.229.254 > > # netmask: The network mask used for the ip's > netmask = 255.255.255.0 > > # cache-size: The gdbm cache size for the db > # files. Should be equal to the number of ip's > # available in the ip pool > cache-size = 768 > > # session-db: The main db file used to allocate ip's to clients > session-db = ${raddbdir}/db.ippool > > # ip-index: Helper db index file used in multilink > ip-index = ${raddbdir}/db.ipindex > > # override: Will this ippool override a Framed-IP-Address already set > override = no > > # maximum-timeout: If not zero specifies the maximum time in seconds an > # entry may be active. Default: 0 > maximum-timeout = 0 > } > > ippool main_pool2 { > > # range-start,range-stop: The start and end ip > # addresses for the ip pool > range-start = 64.202.237.1 > range-stop = 64.202.239.254 > > # netmask: The network mask used for the ip's > netmask = 255.255.255.0 > > # cache-size: The gdbm cache size for the db > # files. Should be equal to the number of ip's > # available in the ip pool > cache-size = 768 > > # session-db: The main db file used to allocate ip's to clients > session-db = ${raddbdir}/db.ippool2 > > # ip-index: Helper db index file used in multilink > ip-index = ${raddbdir}/db.ipindex2 > > # override: Will this ippool override a Framed-IP-Address already set > override = no > > # maximum-timeout: If not zero specifies the maximum time in seconds an > # entry may be active. Default: 0 > maximum-timeout = 0 > } > >- >List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html > > - List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html