Hi Jeanette, Which version of FreeSurfer are you running. Also, can you try renaming the qdec.Qdecrc to .Qdecrc and try again. Here's more info on editing the .Qdecrc file with the new measures.
https://surfer.nmr.mgh.harvard.edu/fswiki/.Qdecrc Sita. On Mon, 13 Jun 2011, Jeanette Berberich wrote: > Hi, > > So I'm trying to add new measures, after having run recon-all -qcache, to my > design tab drop-down menu and it doesn't seem to be working. I was a little > confused about the .Qdecrc file. I put a file named qdec.Qdecrc file inside > my $SUBJECTS_DIR/qdec/ and i also have a qdec.fsgd file in the same place. > I'm not sure what else to do to get my new measurements to show up. > > Thank you so much, > > > Jeanette > _______________________________________________ > Freesurfer mailing list > Freesurfer@nmr.mgh.harvard.edu > https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer > > > _______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.