Hello Everyone, I have an application outside freesurfer where I need the scalp/face surface from the MRI file so I'm trying to use mri_watershed algorithm to generate the scalp surface, but when I read the subject-outer_skin.surf file in matlab using the read_surf command I see that the facial features (nose, eyes, lips, chin) are not clear. But when I viewed the MRI file using mrilab I can see the facial features clearly. So I was wondering if there are parameters I can change while running the mri_watershed alrgorithm so that I can get good face shape. I'm also up for any suggestions/hints.
Here is the command I used to run the mri_watershed: mri_watershed -atlas -useSRAS -surf /../../bem/watershed/subject /../..subject/T1.mgz /../../bem/watershed/ws/ Thanks and Regards, --------------------------------------------------- Santosh Vema KrishnaMurthy, M.A.Sc Medical Devices Engineer NRC Institute for Biodiagnostics (Atlantic) Elekta/IWK MEG Research office Ph: (902) 470-3984 ---------------------------------------------------
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.