Hi Rui - You can ignore the message about spline segments, it's fine.
For the directory structure and where to find your files, I'll refer you
to the trac-all wiki page (see section "Outputs from trac-all -path"):
http://surfer.nmr.mgh.harvard.edu/fswiki/trac-all
Hope this helps,
a.y
On Wed, 18 Jul 2012, Rui Lavrador wrote:
Hi FS users,
I'm running “trac-all –path ” and when running it, it constantly gives the
output
ERROR: Degenerate spline segment
58 81 24
56 69 24
…
But it runs until the end without exiting and says that it ran without errors.
It’s normal?
Plus, it seems that it fails to create the output files. When looking at the
created folder “…/Diff001/dpath” there is only one folder
“5cpts”, so I cannot visualize the WM pathways, with freeview, that should be
located, for example at
“…/dpath/lh.ilf_AS_avg32_mni_flt/path.pd.nii.gz”
Any suggestions?
--
Rui Lavrador
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
