You could probably load them in matlab and compare there. ________________________________________ From: freesurfer-boun...@nmr.mgh.harvard.edu [freesurfer-boun...@nmr.mgh.harvard.edu] on behalf of David Romano [drom...@stanford.edu] Sent: Thursday, September 05, 2013 8:01 PM To: freesurfer@nmr.mgh.harvard.edu Subject: [Freesurfer] tool to compare surface files (along the lines of diff)?
Hi everyone, I'm trying to figure out whether two surfaces which appear identical in freeview are indeed identical. Using diff shows the files are not, but since they're binary, I can't tell whether this difference is simply due to header information that might be embedded in the files, or whether the surfaces do indeed differ. Is there a FreeSurfer command that can be used to determine this? Thanks in advance for your help, David Romano _______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.