you should be able to use mris_preproc
On 10/9/14 1:08 PM, Lars M. Rimol wrote:
Hi,
In the wiki page on the gyrification index it says that to sample the
results to ico, use
recon-all -s my_subject_id -qcache -measure pial_lgi
If I prefer not to use qudec, can I instead use mris_preproc to do the
registration to atlas and concatenate the files and then use
mri_surf2sruf to smooth? And then proceed with inferential statistics?
Thank you!
-----------------------------------------------------------
from the wiki:
The primary output file is ?h.pial_lgi, which can be viewed as an
overlay in tksurfer or freeview:
tksurfer my_subject_id lh inflated -overlay lh.pial_lgi
To perform a vertex-wise analysis in QDEC of the lgi surface data,
first sample the results to the average template subject 'fsaverage':
recon-all -s my_subject_id -qcache -measure pial_lgi
Do this for each of the subjects in your group
--
yours,
Lars M. Rimol, PhD
Norwegian University of Technology and Science (NTNU)
Trondheim,
Norway
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.