Hi all, What command would I use to apply the aparc labels to a different surface (e.g. to $h.ratio.mgh)??
The ratio file was created as follows: mri_vol2surf --src ${nu_mgz} --projfrac +0.35 --surf white --hemi lh --out ${subj_dir}/mri/lh.white.projfrac.pos35.mgh --regheader ${subject} --noreshape mri_vol2surf --src ${nu_mgz} --projdist -1 --surf white --hemi lh --out ${subj_dir}/mri/lh.white.projdist.neg1.mgh --regheader ${subject} --noreshape fscalc ${subj_dir}/mri/lh.white.projfrac.pos35.mgh div ${subj_dir}/mri/lh.white.projdist.neg1.mgh -o ${subj_dir}/mri/lh.ratio.mgh Thanks Corinna
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.