If you are going from 5.3 to 6, you should just be able to run recon-all
-all on the 5.3 folder and it should take into account your previous
edits (make a copy first though:)
On 11/12/2021 4:40 AM, Steve Petersen wrote:
External Email - Use Caution
Dear all,
We conducted the recon-all and applied a quality control protocol in
several subjects using the FSurfer 6 version. Now, we would like to
run the recon-all again on an older version of FSurfer (5.3 v) but
considering the edits we made on those previous recon-all. Is this
possible?, and if so, what would be the command?
Thank you very much in advance.
Best regards,
Steve.
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Mass General Brigham
Compliance HelpLine at http://www.massgeneralbrigham.org/complianceline . If
the e-mail was sent to you in error but does not contain patient information,
please contact the sender and properly dispose of the e-mail.
Please note that this e-mail is not secure (encrypted). If you do not wish to
continue communication over unencrypted e-mail, please notify the sender of
this message immediately. Continuing to send or respond to e-mail after
receiving this message means you understand and accept this risk and wish to
continue to communicate over unencrypted e-mail.