In FreeView
Click on the brain with scissors icon ("Cut"), select your points, then
"Cut Closed Line",
make sure the cusror is in the patch, then hit "Fill Uncut Area",
then save as a patch
On 3/7/2022 12:03 PM, Francesca Strappini wrote:
External Email - Use Caution
Dear FreeSurfer experts,
I'm trying to cut and flatten the full surface. I understand that
tksurfer is deprecated and on my PC does not work properly. Is there
an alternative way to perform the cuts?
Thank you,
Francesca
--
Francesca Strappini, Ph.D.
Psychology Department
Sapienza University of Rome
Via dei Marsi 78, Rome 00185 Italy
Tel.: +39 392 151 4029
E-mail: francesca.strapp...@uniroma1.it
<mailto:francescastrappini.s...@uniroma1.it>
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Mass General Brigham
Compliance HelpLine at https://www.massgeneralbrigham.org/complianceline
<https://www.massgeneralbrigham.org/complianceline> .
Please note that this e-mail is not secure (encrypted). If you do not wish to
continue communication over unencrypted e-mail, please notify the sender of
this message immediately. Continuing to send or respond to e-mail after
receiving this message means you understand and accept this risk and wish to
continue to communicate over unencrypted e-mail.
