Yes, just specify --regheader subjectname instead of a --reg
On 3/11/2022 9:34 AM, Jacoby, John wrote:
Hi all,
Usually when I want to map volume data to the fsaverage surface, I use
mri_vol2surf with a registration that transforms the volume into the
space of the subject's orig.mgz and with --trgsubject set to
'fsaverage'. Currently, I have some volumes that have already been
transformed to the subjects' orig.mgz space that I want to bring to
the fsaverage surface. Can I still just give mri_vol2surf the same
registration that I used to transform this volume in the first place,
or will this try to re-apply that registration and end up in the wrong
space? If that's incorrect, what's the best way to go about doing this?
Thank you!
Best,
John
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Mass General Brigham
Compliance HelpLine at https://www.massgeneralbrigham.org/complianceline
<https://www.massgeneralbrigham.org/complianceline> .
Please note that this e-mail is not secure (encrypted). If you do not wish to
continue communication over unencrypted e-mail, please notify the sender of
this message immediately. Continuing to send or respond to e-mail after
receiving this message means you understand and accept this risk and wish to
continue to communicate over unencrypted e-mail.
