You need to add --save-input (just added a note to the wiki)
On 10/14/2022 9:22 AM, Marina Fernández wrote:
External Email - Use Caution
Dear experts,
I would like to get a noPVC PET volume scaled by the intensity of the
pons, then project it and apply standard surface-based analysis. On
the PetSurfer website it says:
**
If you do not want to perform PVC, you can just run
mri_gtmpvc --i pet.nii.gz --reg template.reg.lta --seg gtmseg.mgz
--default-seg-merge --auto-mask 1.01 --no-tfe --o gtmpvc.output
**
If I do this, I cannot find any output in the folder which I can
project on the surface corresponding to the non-PVC PET volume
referenced to the pons.
The idea is to have comparable PET-PVC vs. PET-noPVC data scaled to
the pons in both cases. In order to do this, should I divide
(externally to the mri_gtmpvc function) each voxel of the PET image by
the average of the pons?
Thank you very much in advance.
Best regards,
Marina
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Mass General Brigham
Compliance HelpLine at https://www.massgeneralbrigham.org/complianceline
<https://www.massgeneralbrigham.org/complianceline> .
Please note that this e-mail is not secure (encrypted). If you do not wish to
continue communication over unencrypted e-mail, please notify the sender of
this message immediately. Continuing to send or respond to e-mail after
receiving this message means you understand and accept this risk and wish to
continue to communicate over unencrypted e-mail.
