Hi, no snapshots were attached.
On 2/1/2024 6:02 AM, Luisa Klahn wrote:
External Email - Use Caution
Hello!
I am processing structural data from a 3T scanner using Freesurfer
version 7.3.2. For some subjects, the grey matter looks very thin, and
the white matter looks overestimated. I'll attach screenshots of the
brainmask, wm mask, and T1 including wm and pial surface lines.
I have tried to set control points into the wm but this did not change
the results.
Does anyone have an idea? Would it be possible to change the intensity
settings in the recon-all command?
Thanks for helping!
Luisa
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Mass General Brigham
Compliance HelpLine at https://www.massgeneralbrigham.org/complianceline
<https://www.massgeneralbrigham.org/complianceline> .
Please note that this e-mail is not secure (encrypted). If you do not wish to
continue communication over unencrypted e-mail, please notify the sender of
this message immediately. Continuing to send or respond to e-mail after
receiving this message means you understand and accept this risk and wish to
continue to communicate over unencrypted e-mail.
