vertices require a surface. There is no surface for cerebellum, so the
vertices are all marked -1 to indicate that the vertex indices are not
valid. The XYZ values are valid though
On 4/9/2024 6:36 AM, Sam W wrote:
External Email - Use Caution
Hello!
I'm trying to convert the cerebellum cortex in the aparc+aseg.mgz into
a label so I tried:
mri_vol2label --c bert/mri/aparc+aseg.mgz --id 8 --l lh.cerebellum.label
but the resulting output file only has -1 as vertices. Is there
anything wrong with the command above?
Best regards,
Sam
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Mass General Brigham
Compliance HelpLine at https://www.massgeneralbrigham.org/complianceline
<https://www.massgeneralbrigham.org/complianceline> .
Please note that this e-mail is not secure (encrypted). If you do not wish to
continue communication over unencrypted e-mail, please notify the sender of
this message immediately. Continuing to send or respond to e-mail after
receiving this message means you understand and accept this risk and wish to
continue to communicate over unencrypted e-mail.
