External Email - Use Caution Dear FreeSurfer developers,
I am interested in understanding where the freesurfer default intensity values for gray and white matter specifically come from within the recon-all command. I understand the default intensity of white matter (mean) is 110, white matter (low) is 90, white matter (high) is 125, gray matter (low) is 30, and gray matter (high) is 100. I know that the default parameters are meant to improve segmentation of the gray and white matter tissue but could you please tell me how/where these values come from? I’ve read the 2002 paper “Whole Brain Segmentation: Automated Labeling of Neuroanatomical Structures in the Human Brain” and I saw that Figure 1 had varying distributions for gray and white matter intensity, but I did not see anything that explicitly stated how these default values were chosen. Your guidance is appreciated, Sanna Lokhandwala
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Mass General Brigham Compliance HelpLine at https://www.massgeneralbrigham.org/complianceline <https://www.massgeneralbrigham.org/complianceline> . Please note that this e-mail is not secure (encrypted). If you do not wish to continue communication over unencrypted e-mail, please notify the sender of this message immediately. Continuing to send or respond to e-mail after receiving this message means you understand and accept this risk and wish to continue to communicate over unencrypted e-mail.