Good evening, I did send this earlier, but thought I would add another couple of comments to see if anyone has any ideas whatsoever. It has been driving me a little bit mad today !!
I have configured a couple of Nokia IP380's, four interfaces. Configured IPSO clustering successfully, and all comes up fine, although at the moment, I have Firewall Monitoring disabled. Configured the Checkpoint environment, as per the Nokia document, still works OK. As soon as I go back to edit the cluster, and turn on Firewall monitoring, it all goes wrong. The error message across the top of the screen comes back and says "Firewall Check Failed, Clustering requires firewall installed on each node" Searched everywhere, cant find any technote which might describe what the problem might be. I have also reduced it to a single node, clustering wise, but still get the same error, and unable to initialise the cluster, as before. Would appreciate any suggestions. Thanks. ##################################################################################### This e-mail message has been scanned for Viruses and Content and cleared by 3DMail ##################################################################################### ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
