I have tried 4.5.21 which is what my other Edges are using with no trouble. I have also tried 4.5.64x and 5.0.50x and can establish a tunnel of sorts but I can only ping to the Edge and not back to the corporate network like I can with the other Edge boxes.
It should not be this difficult. All three Edge boxen are set up the same and I can only talk to two. Stephen W. Stewart -----Original Message----- From: Mailing list for discussion of Firewall-1 [mailto:[EMAIL PROTECTED] On Behalf Of Russell Aspinwall Sent: Wednesday, February 16, 2005 8:15 AM To: [email protected] Subject: Re: [FW-1] VPN-1 Edge X Setup Hi, I have used a variety of firmware versions on the Edge and found v5.0.43x a vast improvement since v4.0.93x and many in between. Site to Site VPNs offer a significantly better level of performance and reliability, primarily NGAI R55 to Edge, Edge to Edge VPNs have not been a problem. Stephen W. Stewart wrote: > Hi All, > > Trying to set up an Edge X box for a remote office in Site to Site mode. > I currently have 2 other sites that are working just fine. The only > difference with the new X is that it will have a static IP and the two > that are working are using DHCP. > > I can create the site and then look in the reports section at the VPN > Tunnels section and nothing shows up. If I ping the internal IP of > the X box a tunnel is established and the X box replies. I cannot > ping the other way into the "home" network behind the FW-1. > > The established tunnel shows IKE (Phase 1): 3DES/SHA1. > > Any ideas? > > Thanks > > > Stephen W. Stewart > > ================================================= > To set vacation, Out-Of-Office, or away messages, send an email to > [EMAIL PROTECTED] > in the BODY of the email add: > set fw-1-mailinglist nomail > ================================================= > To unsubscribe from this mailing list, please see the instructions at > http://www.checkpoint.com/services/mailing.html > ================================================= > If you have any questions on how to change your subscription options, > email [EMAIL PROTECTED] > ================================================= > -- Regards Russell ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] ================================================= ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
