That is fine, but what it is looking for is 'install' user in /etc/passwd with same uid as that of a root user - look in /etc/passwd for a user named 'install' and ensure its uid matches 0 or if it is not there, create a user named 'install' with a uid 0 -
We were also installing our prod systems last week as 'root' only. Hope this clarifies.. Rajeev On 5/9/06, cisco4ng <[EMAIL PROTECTED]> wrote:
Hi Rajeev, I install Provider-1 as "root" user. cisco4ng Rajeev Gupta <[EMAIL PROTECTED]> wrote: See if you have 'install' user in the etc/passwd file and if so, give it 'root' priviliges with uid of 0 or create an 'install' user with uid 0. We had two MDS containers built last week and had to do this on both of them to work - rm'ng patach did not work. hth. Rajeev On 5/9/06, cisco4ng wrote: > Hi Eamonn, > > thank you very much for your reply. I already did that before asking everyone in this > forum. The Sun cluter patch comes with 113713-19 so I did "patchrm 113713-19" and > then rebooted the box afterward. > > Well, the installation of Providder-1 NG with AI R55 went ok but near the end of > the installation, I got core dump (segmentation faulted). My thought is to use > Provider-1 on SPLAT but I have a spare Sun Ultra 60 that I thought it may be useful > as a test Provider-1 for me. > > I've done numerous Provider-1 NG with AI R55 installation without major issues until > yesterday. Most of the time, I just do "patchrm 113713-18" and that will do the trick. > Apparently, stupid Sun/Checkpoint update the cluster patch and now I have issues. > > If you have anymore ideas, please let me know. As always, TIA. > > cisco4ng > > Eamonn Twohig wrote: > hi cisco4ng, > > i read on another forum, where someone said that they had done the > following to get around the problem u are seeing: install solaris 9, > then install the latest sun patch cluster available; then completely > remove patch 113713 (whatever variation), install checkpoint product in > question, and finally re-install patch 113713 (whatever variation). the > user said that the problem arose with sun patch 113713 when the revision > went higher than 16 ... so 113713-16 was the last known 'good' patch for > whatever 113713 is for. > > hope this helps, i haven't tried it myself as i'm still on solaris 8. > > later, > eamonn > > -----Original Message----- > Sent: 09 May 2006 04:56 > To: [email protected] > Subject: [FW-1] Provider-1 installation issue with Solaris 9 > > can someone help me with this? > > I installed a fresh full install of Solaris 9 on an Ultra-60 (dual > 300Mhz CPU with 2GB of RAM). After the installation, I reboot the > system and then I installed Solaris 9_SunAlert_Patch_Cluster.zip (aka > hotfix) and reboot the box one more time. > So far so good. > > When I proceed to install Provider-1 NG with AI R55, I kept getting > error. I remembered seeing this before, something about the sun patch > 113713-19 so I removed the patch with the command "patchrm 113713-19" > and then I installed patch 113713-22 instead. I still kept getting > error with checkpoint whenever I run the "./mds_setup" command. At the > moment, my solaris box is clean because I ran the "cpclean" to remove > all the checkpoint packages. > > Can someone help me out here? I must be missing something very simple > here > > As always, TIA > > cisco4ng > > ================================================= > To set vacation, Out-Of-Office, or away messages, > send an email to [EMAIL PROTECTED] > in the BODY of the email add: > set fw-1-mailinglist nomail > ================================================= > To unsubscribe from this mailing list, > please see the instructions at > http://www.checkpoint.com/services/mailing.html > ================================================= > If you have any questions on how to change your > subscription options, email > [EMAIL PROTECTED] > ================================================= > > > > --------------------------------- > Love cheap thrills? Enjoy PC-to-Phone calls to 30+ countries for just 2ยข/min with Yahoo! Messenger with Voice. > > ================================================= > To set vacation, Out-Of-Office, or away messages, > send an email to [EMAIL PROTECTED] > in the BODY of the email add: > set fw-1-mailinglist nomail > ================================================= > To unsubscribe from this mailing list, > please see the instructions at > http://www.checkpoint.com/services/mailing.html > ================================================= > If you have any questions on how to change your > subscription options, email > [EMAIL PROTECTED] > ================================================= > ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] ================================================= ________________________________ Yahoo! Messenger with Voice. PC-to-Phone calls for ridiculously low rates.
================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
