Actually DTP is:
Dynamic Trunking Protocol (DTP), a Cisco proprietary protocol in the VLAN
group, is for negotiating trunking on a link between two devices and for
negotiating the type of trunking encapsulation (802.1Q) to be used.
GVRP is GARP VLan Registration Protocol (GARP is Generic Attribute
Registration Protocol) as defined by 802.1Q
Roger Herr
WhyNot? Consulting Services
24165 IH 10 West Suite 217-183
San Antonio, Texas 78257
210-860-3990
Some men see things as they are and say why?
I dream things that never were and say "Why Not?"
-Robert F. Kennedy
Or the original
You see things; and you say "Why?" But I dream things that never were; and I
say "Why not?"
George Bernard Shaw
(1856-1950)
----- Original Message -----
From: "sin" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Sunday, March 18, 2007 12:29 PM
Subject: Re: [FW-1] VPN Deployment Issue
Christopher McGill wrote:
No, I mean DTP (Dynamic Trunking Protocol), which is used to
automatically
generate a trunk with another switch.
ah, GVRP.
You carry management traffic over the
native vlan, and if you are not using stackwise +. then every switch will
have an IP, including access-layer switches which you will be connecting
to,
and hence your management traffic will be carried over vlan 1 to the
switches.
true, but so far I worked with switches that I could assign an IP address
inside a VLAN (and no, not SVI interfaces) for management purposes.
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [EMAIL PROTECTED]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[EMAIL PROTECTED]
=================================================
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [EMAIL PROTECTED]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[EMAIL PROTECTED]
=================================================
