Corrado Motta a écrit :
Hi gurus,
we'd like to replace the "old" HW with a new One.
My think was:
a) I install a Secondary SCS on a temp-new HW (trial Period License)
b) Configure it on My primary
c) I sync the rules Policy / internal_CA / VPN / ...
d) I made the secondary Active. and delete the primary SCS
e) Install the new primary SCS on new HW
f) configure it on my secondary
g) Sync the new-Primary with the active SCS
h) make the primary active and delete the secondary.
hi,
with this scenario you'll lose your logs because the logs are not
synchronized.
it's definitely recommended to :
- backup your primary smartcenter
- run an upgrade_export from the primary.
- shutdown/disconnect the primary
- install the new hardware with the exported config
- check that you get logs and proper status
1st question:
Is this procedure correct?
2nd
Smart-Dashboard->Policy->Management HA, The button "Synchronize" give
this
error:
"Failed to Synchronize. Reason: Secondary failed to initialize
internal CA
"
Whats wrong in my c) task ?
Like always, thank you in advance
Regards
Corrado
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [EMAIL PROTECTED]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[EMAIL PROTECTED]
=================================================
