Works fine, thx! > Try the following: > > -cpstop > > - edit or create (if still not there) the file $FWDIR/conf/discntd.if, > adding on that file the list of interfaces you don't need to be included in > the cluster, just add their names (as shown in ifconfig), one by line. > > -cpstart > > -do the same with every firewall module in the cluster. > > Hope this helps. > > Regards > > On 5/15/07, Markus Schmidt <[EMAIL PROTECTED]> wrote: >> >> Hi everyone, >> >> I'm running a Cluster Installation (HA) on R65 with Splat. The machines >> have 5 Network interfaces, where one of them is part of 2 VLANS. >> Now my Problem: >> eth4 is allwasy down, because it is not used. It has no IP assigned, and >> is not Part of the topology table. Nevertheless, cphaprob states that it >> causes a problem. >> Second is the VLAN eth0.2. >> This gows up and down at will, because the switch, to wich I don't have >> access, is poorly configured. So I'd like to "don't care" for eth0.2? >> So is there a way to remove eth4 and eth0.2 from causing a failover? >> I tried cphaprob -d ethX unregister, but this is not working. >> Any suggestions? >> >> regards Markus >> -- >> http://schmidt.bs-server.com >> >> ================================================= >> To set vacation, Out-Of-Office, or away messages, >> send an email to [EMAIL PROTECTED] >> in the BODY of the email add: >> set fw-1-mailinglist nomail >> ================================================= >> To unsubscribe from this mailing list, >> please see the instructions at >> http://www.checkpoint.com/services/mailing.html >> ================================================= >> If you have any questions on how to change your >> subscription options, email >> [EMAIL PROTECTED] >> ================================================= >> > > >
-- http://schmidt.bs-server.com ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
