Do you allow echo-request from your source to that IP? Is that NAT set up correctly from your source to that IP?
Does the router have routes back to your source IP? Anything in SmartView Tracker? On Wed, Sep 9, 2009 at 1:48 PM, Mike Darr<[email protected]> wrote: > When you say get interfaces you mean in the topology section for the gateway? > If so, yes. Not sure there should be a policy for this. It is just an outside > interface. We do not have one for the existing. We do not on our router. > > -----Original Message----- > From: Mailing list for discussion of Firewall-1 > [mailto:[email protected]] On Behalf Of Gary Scott > Sent: Wednesday, September 09, 2009 10:10 AM > To: [email protected] > Subject: Re: [FW-1] 2 T-1's > > Did you do a get interfaces after adding the new one? Policy allowing this? > NAT in the way? > > -GS > > > > ________________________________ > From: Mike Darr <[email protected]> > To: [email protected] > Sent: Wednesday, September 9, 2009 8:11:41 AM > Subject: Re: [FW-1] 2 T-1's > > We are in the process of moving our Verizon line to an ATT line. I hung a hub > off the outside of the firewall to connect two T-1's, Verizon and ATT. For > some reason I cannot ping the new ATT router. It is on the same network as > the outside firewall address. I rebooted the firewall and all routers with no > success. I can ping the ATT router from the Verizon router and the firewall, > but nothing inside out. I show it goes through in Tracker. Tarcert shows it > stops at the inside address of the firewall. Has to be something minute. > > Mike > > -----Original Message----- > From: Mailing list for discussion of Firewall-1 > [mailto:[email protected]] On Behalf Of Gary Scott > Sent: Tuesday, September 08, 2009 4:06 PM > To: [email protected] > Subject: Re: [FW-1] 2 T-1's > > You can have as many routers hung off the FW as you want. What exactly are > you looking to do? > > -GS > > ________________________________ > From: Mike Darr <[email protected]> > To: [email protected] > Sent: Tuesday, September 8, 2009 3:03:11 PM > Subject: [FW-1] 2 T-1's > > Is it possible to hang two routers off the back of a Checkpoint Firewall? > > Thanks > Mike Darr > Scanned by Check Point Total Security Gateway. ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [email protected] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [email protected] =================================================
