We tried turning portfast on at both Switches. Didn't help
Put the FW's into the same hub and all is well. But we don't want to leave
it this way. We would like to have each into a separate switch that is then
uplinked as a fault tolerant design.
-----Original Message-----
From: Ville Laitinen [mailto:[EMAIL PROTECTED]]
Sent: Monday, July 03, 2000 3:42 PM
To: Tom Sevy
Cc: Check Point FW List (E-mail)
Subject: Re: [FW1] VRRP problem
Spanning tree perhaps, you did set the switch ports to 'portfast'
and check the duplex/speed settings ?
-Ville
Tom Sevy wrote:
>
> Found that the Virtual circuit in question has (eth-s1p3c0 on both
IP440's)
> are going into redundant Catalyst 3548 switches.
>
> So from FW#1, this interface goes to Port 1 on the first switch
> and on FW#2, this interface goes to Port 1 on the second switch
>
> Switches are connected with Gigabit uplinks. It doesn't appear that FW#2
is
> seeing the advertisements from FW#1.
>
> -----Original Message-----
> From: hermit1 [mailto:[EMAIL PROTECTED]]
> Sent: Monday, July 03, 2000 1:30 PM
> To: Tom Sevy; Check Point FW List (E-mail)
> Subject: Re: [FW1] VRRP problem
>
> Check that the interface in backup state on the first FW is monitoring the
> correct interfaces. Took me two hours to find this one when it happened
to
> me - it was eth-s1p2 instead of eth-s1p3 in a long list of monitored
> interfaces.
> Check that the priorities are all correct.
>
> hermit1
>
> At 12:28 PM 7/3/00 -0400, Tom Sevy wrote:
>
> >Two IP440's, VRRP running.
> >
> >Two quad eth cards in each.
> >
> >5 interfaces active, paired monitered circuits including VRRP circuit.
> >
> >If both IP440's are up & running, 4 interfaces on first FW are in master
> >state, one in backup, and opposite on 2nd FW.
> >
> >Any suggestions?
>
>
============================================================================
====
> To unsubscribe from this mailing list, please see the instructions at
> http://www.checkpoint.com/services/mailing.html
>
============================================================================
====
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================
