I think the problem is in the footprints. For to TO-18 I wrote TO-18 and I'm thinking gsch2pcb is getting stuck there.
On Sun, Aug 17, 2008 at 6:25 PM, <[EMAIL PROTECTED]> wrote: > > I'm trying to run a very simple schematic thru gsch2pcb and it's getting > > stuck. The printout says: using the m4 processor for pcb footprints > > Are you using newlib (file type) or M4 footprints? I rename the directory > for the M4 stuff and only use newlib footprints that I create. > > Does gsch2pcb stop at a point and tell you the results of it's job? > > > Aside > > from that it's just a thru hole definition. Any ideas? > > This shouldn't make any difference. > > Phil > > > > _______________________________________________ > geda-user mailing list > geda-user@moria.seul.org > http://www.seul.org/cgi-bin/mailman/listinfo/geda-user >
_______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
